Schedule Network/Internet Access Sky Hub 2 (SR102)

Back in 2013 I created a post and video guide detailing how to schedule/block internet access for a specific device (Or devices) on your Sky Broadband wireless router. I was requested again by a follower to do the same for the newer Sky Hub (SR102).

The original post can be found by clicking here.

The process we go through for this is the same as before, we’ll set a Static IP for the device you wish to restrict access to, then we’ll set the schedule and enforce the firewall rule to make it work.


Note: As before it isn’t possible to have multiple schedules for multiple devices.

  1. Start by accessing the Sky Hub control panel via your internet browser. The access address is and the username/password, if not changed from the default is admin/sky. If you are not prompted for these, you may be after the next step.
  2. Click the Advanced menu option followed by LAN IP Setup.
  3. Scroll down to the Address Reservation section and click the Add button.
  4. A list of devices connected to the Sky Hub will be shown – select the radio button next to the device you wish to control access for and then click Add at the bottom. Take a note of the IP Address. (It’ll be 192.168.0.X)
  5. You will be notified the Sky Hub will reboot, agree to this and wait for the page to come back up. It takes a couple of minutes.
  6. Once back up, select Security followed by Schedule.
  7. On this screen you’ll select the days and hours for the schedule to block access during. Note that the time is 24-Hour (Enter 3.30PM as 15 Hour, 30 Minute). You can also check the Sky Hub has the correct time/day at the bottom – once done click Apply.
  8. Head now to Security followed by Firewall Rules.
  9. Beneath the Outbound Services click the Add button.
  10. Change the service option to Any(ALL) and the action to BLOCK by schedule.
  11. LAN Users should be changed to Single Address – enter the address noted for your device in Step 4.
  12. Click Apply to add the Firewall Rule.
  13. Click Apply again to save the Firewall Rules Changes.

This is all that is required, my previous guide was very successful and popular in the Sky community, it is unfortunate that Sky themselves don’t provide guidance.

A video guide has been provided below.

4 thoughts on “Schedule Network/Internet Access Sky Hub 2 (SR102)

  1. When I add a second device on the schedule it doesn’t give me the ‘any all’ option on the pull down menu. Please would you advise what ‘service’ I should select? Thanks

  2. Hey Chris, my sky hub is also showing an IPv6. How do I block with the IPv6? my device is still able to connect to certain websites and blocked on others…it's a windows pc.
    It's weird how some websites the pc is blocked and on others it can connect, I know I've done it right cos of this and I'm assuming it's to do with this IPv6?

  3. I would recommend that you reserve each device an IP address in a sequence like then and so on. When configuring the rule you'd then apply it to a range of IP addresses (Above would be – and it'll apply to them all.

Leave a Reply

Your email address will not be published. Required fields are marked *